NTC Type III Temperature Sensor, 10K Ohm, Immersion Sensor for Hot or Chilled Water, 5 Inch Insertion, -40/250 Degree Operating Temperature, Used with Webs-AX I/O Modules
Existing reviews
Repair Outcome
4
The appliance suddenly stopped working properly on our appliance ended up being caused by a failing part. Access was a little tight behind the panel and the replacement solved it.
Guest|7/4/2025 9:36 AM
Was this review helpful?YesNo (0/0)
Installation Experience
5
Installed this when the older unit needed replacement part. Needed basic hand tools only. Everything powered back on correctly afterward. Repair turned out easier than expected honestly.
Scotty|9/29/2025 9:36 AM
Was this review helpful?YesNo (0/0)
Repair Outcome
5
Wasnt completely sure this would match at first since the appliance suddenly stopped working properly. Thankfully access was a little tight behind the panel and everything is working again.
Scotty|11/23/2025 8:36 AM
Was this review helpful?YesNo (0/0)
Compatibility Feedback
5
After dealing with a situation where the original component had worn out over time, we installed this replacement part. Repair solved the original problem.
Peter|3/19/2026 9:36 AM
Was this review helpful?YesNo (0/0)
Only registered users can write reviews
WATER PIPE SENS 10K OHMS For Honeywell Part# C7023D2001