Flush Mount Sensor, 10K Ohm NTC Type III Non Linear, Wall Flush Mount Sensor without Logo, 45/99 Degree Operating Temperature Range, 5/95% RH Non Condensing Operating Humidity Range, Used with WEBs-AX I/O Modules

Existing reviews

Repair Outcome

After dealing with a situation where the original component had worn out over time, we installed this replacement part. No leaks or issues noticed so far. Part quality feels reasonable compared to original one.

From: Bob | Date: 11/25/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Installation Experience

Installed this when the appliance suddenly stopped working properly. Connector alignment matched better than expected. No leaks or issues noticed so far. Worth verifying model number before ordering though.

From: Scotty | Date: 1/4/2026 8:36 AM

Was this review helpful? Yes No (0/0)

Helpful Product Insight

Wasnt completely sure this would match at first since the older unit needed replacement part. Thankfully mounting holes lined up correctly during install and everything is working again.

From: Guest | Date: 3/27/2026 9:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews