Unit Ventilator Pneumatic Thermostat, 2 Pipe, Single Setpoint, Direct Acting Heating, Reverse Acting Cooling, 18 PSI Heat Changeover, 13 PSI Cooling Changeover, 65-85 Degree Setpoint Temperature Range, 3.5 Degree Throttling Range, Warmer/Cooler Scale Markings, 1/2"x5 7/8" Bulb, 36" Capillary Length

Existing reviews

Repair Outcome

Had to double check model compatibility first while replacing the old component because the original component had worn out over time. Appliance has been running normally since then.

From: Guest | Date: 10/5/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Installation Experience

Wasnt completely sure this would match at first since the original component had worn out over time. Thankfully needed basic hand tools only and everything is working again.

From: Guest | Date: 11/5/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Repair Outcome

Wasnt completely sure this would match at first since the original component had worn out over time. Thankfully installation wasnt too difficult overall and everything is working again.

From: Guest | Date: 2/26/2026 8:36 AM

Was this review helpful? Yes No (0/0)

Repair Outcome

Connector alignment matched better than expected while replacing the old component because the older unit needed replacement part. Everything powered back on correctly afterward.

From: Bob | Date: 3/16/2026 9:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews