Hot Surface Ignitor, 120 Vac, Silicon Carbide, Natural or Lp Gas, 5 1/4" Lead Length, Standard with Rib Offset from Left Edge Mounting, 392 Degree Temperature Rating, Molex Front Lock Connector with .092 Male Pins

Existing reviews

Compatibility Feedback

After dealing with a situation where the original component had worn out over time, we installed this replacement part. No leaks or issues noticed so far. Part quality feels reasonable compared to original one.

From: Guest | Date: 6/26/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Replacement Observation

Installation wasnt too difficult overall while replacing the old component because the appliance suddenly stopped working properly. Appliance has been running normally since then.

From: Scotty | Date: 12/3/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Compatibility Feedback

After dealing with a situation where the appliance suddenly stopped working properly, we installed this replacement part. Everything powered back on correctly afterward. Would probably order again if needed.

From: Peter | Date: 4/4/2026 9:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews