Hot Surface Ignitor, 120 Vac, Silicon Carbide, Natural or Lp Gas, 5 1/2" Lead Length, Standard with Rib on Right Edge Mounting, 392 Degree Temperature Rating, Molex Internally Keyed Connector with .084" Male Pins

Existing reviews

Repair Outcome

The original component had worn out over time on our appliance ended up being caused by a failing part. Fitment on our appliance was accurate and the replacement solved it.

From: Bob | Date: 1/7/2026 8:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

After dealing with a situation where the original component had worn out over time, we installed this replacement part. Appliance has been running normally since then. Would probably order again if needed.

From: Peter | Date: 1/18/2026 8:36 AM

Was this review helpful? Yes No (0/0)

Installation Experience

Had to replace this after our original component had worn out over time. Needed basic hand tools only. Unit completed a full cycle without issues.

From: Guest | Date: 3/15/2026 9:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews