Hot Surface Ignitor, 120 Vac, Silicon Carbide, Natural or Lp Gas, 5" Lead Length, Standard with Rib Offset from Left Edge Mounting, 392 Degree Temperature Rating, Molex Front Lock Connector with .092 Male Pins

Existing reviews

Repair Note

After dealing with a situation where the original component had worn out over time, we installed this replacement part. No leaks or issues noticed so far. Would probably order again if needed.

From: Guest | Date: 7/20/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

Took around thirty minutes from start to finish while replacing the old component because the older unit needed replacement part. Noise issue disappeared after replacement.

From: Guest | Date: 12/10/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Helpful Product Insight

Connector alignment matched better than expected while replacing the old component because the older unit needed replacement part. No leaks or issues noticed so far.

From: Peter | Date: 1/29/2026 8:36 AM

Was this review helpful? Yes No (0/0)

Repair Outcome

The appliance suddenly stopped working properly on our appliance ended up being caused by a failing part. Fitment on our appliance was accurate and the replacement solved it.

From: Guest | Date: 4/11/2026 9:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews