Non Spring Return Direct Coupled Actuator, 24Vac, 88 Lb-In Torque, Nema 2 Rated, 0/2-10Vdc, 4-20Ma with 500 Ohm Resistor, On/Off, SPDT, Floating Control Signal, Manul Declutch Mechanism, 0/2-10Vdc Feedback, 95 ± 3 Degree Rotational Stroke, 95 Second Nominal Drive Timing, 1/4"-1/2" Square or 3/8"-5/8" Round Damper Shafts, -5-140 Degree Ambient Temperature Rating, 5-95%RH Non Condensing Oeprating Humidity Range, Includes Mounting Bracket, Screws, Shaft Adapter and Water Tight Strain Relief Cable Fittings
Existing reviews
Helpful Product Insight
5
Used this replacement after the older unit needed replacement part. Needed basic hand tools only. Appliance has been running normally since then. Packaging was decent and part arrived undamaged.
Guest|8/17/2025 9:36 AM
Was this review helpful?YesNo (0/0)
Installation Experience
4
Wasnt completely sure this would match at first since the original component had worn out over time. Thankfully mounting holes lined up correctly during install and everything is working again.
Guest|12/3/2025 8:36 AM
Was this review helpful?YesNo (0/0)
Compatibility Feedback
4
After dealing with a situation where the older unit needed replacement part, we installed this replacement part. Noise issue disappeared after replacement. Repair turned out easier than expected honestly.
Guest|5/5/2026 9:36 AM
Was this review helpful?YesNo (0/0)
Only registered users can write reviews
Mod/FltgAct24vac/dc 88# For Honeywell Part# MN7510A2001