Infrared Flame Detector, Lead Sulfide, 48" Lead Length, 3/4" NPT Mounting, -20/125 Degree Operating Range, Used for Combination or Dual Fuel Applications, Detects Pilot and Main Flame, Includes Magnifying Lens, Sulfide Cell, Orifice, Heat Block and Reducer Bushing

Existing reviews

Compatibility Feedback

The older unit needed replacement part on our appliance ended up being caused by a failing part. Connector alignment matched better than expected and the replacement solved it.

From: Scotty | Date: 10/10/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Replacement Observation

Wasnt completely sure this would match at first since the older unit needed replacement part. Thankfully took around thirty minutes from start to finish and everything is working again.

From: Bob | Date: 4/3/2026 9:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

Mounting holes lined up correctly during install while replacing the old component because the appliance suddenly stopped working properly. Cooling performance seems stable again.

From: Guest | Date: 4/22/2026 9:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews