Electronic-Pneumatic Transducer, Used to Convert a Proportional Electric Output Signal from a Controller into a Direct Acting Proportional Pneumatic Signal, Screw Terminals for 14 or 22 Gage Wire, 2-10Vdc Input Signal, Voltage is Powered by Control Signal, 0.025 Scfm Airflow Usage, Dual Barb Fittings for 1/4" or 5/32" O.D. Plasting Tubing, 30 Psi Maximum Operating Pressure, 0-18 Psi Pressure Range, 3-15 Psi Output Pressure Range, 0.45Cfm Capacity

Existing reviews

Replacement Observation

Connector alignment matched better than expected while replacing the old component because the original component had worn out over time. Noise issue disappeared after replacement.

From: Peter | Date: 10/26/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Installation Experience

Wasnt completely sure this would match at first since the appliance suddenly stopped working properly. Thankfully access was a little tight behind the panel and everything is working again.

From: Bob | Date: 11/3/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Repair Outcome

Wasnt completely sure this would match at first since the original component had worn out over time. Thankfully access was a little tight behind the panel and everything is working again.

From: Guest | Date: 12/13/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

The older unit needed replacement part on our appliance ended up being caused by a failing part. Connector alignment matched better than expected and the replacement solved it.

From: Bob | Date: 5/4/2026 9:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews