Non Spring Return Direct Coupled Damper Actuator, 24Vac, On/Off, SPDT, Floating Control Signal, 90 Second Nominal Driving Time, 35 Lb-In Torque, 3/8"-1/2" Square or Round Shaft, 20-125 Degree Ambient Temperature, 5-95% RH Operating Humidity Range, includes Qty 2 of 5/8"x7/8" Double Knock Out Conduit Openings
Existing reviews
Helpful Product Insight
4
Ended up ordering this because the appliance suddenly stopped working properly. Installation wasnt too difficult overall. Cooling performance seems stable again. Packaging was decent and part arrived undamaged.
Scotty|9/5/2025 9:36 AM
Was this review helpful?YesNo (0/0)
Repair Note
5
Installed this when the older unit needed replacement part. Connector alignment matched better than expected. Unit completed a full cycle without issues. Would probably order again if needed.
Guest|9/8/2025 9:36 AM
Was this review helpful?YesNo (0/0)
Repair Note
4
Wasnt completely sure this would match at first since the original component had worn out over time. Thankfully installation wasnt too difficult overall and everything is working again.
Peter|10/21/2025 9:36 AM
Was this review helpful?YesNo (0/0)
Replacement Observation
5
After dealing with a situation where the original component had worn out over time, we installed this replacement part. Appliance has been running normally since then.
Peter|11/30/2025 8:36 AM
Was this review helpful?YesNo (0/0)
Only registered users can write reviews
DCA 24V 35# 90sec DClucth SPDT For Honeywell Part# ML6161D2006