Pneumatic Damper Actuator, Medium Actuator Force, 10 PSI Span on Positive Positioner, 4" Stroke, Spring Return, 25 PSI Maximum Operating Pressure, 6.6 Square Inch Diaphragm, Dual Barbed Fitting for 5/32" or 1/4" OD Tubing Actuator Air Connection, 5/32" Barb For Pilot, 1/4" Barb For Main , 1/4" Barb for Branch -28-160 Degree Temperature Range, 5-95% RH Humidity Range, Includes Mounting Bracket for Internal Normally Closed Trunnion Mounting

Existing reviews

Repair Note

Ended up ordering this because the original component had worn out over time. Connector alignment matched better than expected. Everything powered back on correctly afterward.

From: Guest | Date: 9/1/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Installation Experience

Used this replacement after the older unit needed replacement part. Needed basic hand tools only. Everything powered back on correctly afterward. Worth verifying model number before ordering though.

From: Bob | Date: 9/14/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

Had to double check model compatibility first while replacing the old component cause the older unit needed replacement part. Unit completed a full cycle without issues.

From: Scotty | Date: 2/12/2026 8:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews