Valve,Ball, 4", 125# flanged, 2 Way, 197cv, 240psi pressure rating, cast iron body, 316 stainless steel ball and stem, epdm o-rings, teflon seals, equal percentage, field configurable for normally open or normally closed, 24v, for control of hot and chilled water with glycol solutions up tp 50% valve body

Existing reviews

Compatibility Feedback

Connector alignment matched better than expected while replacing the old component because the small leak developed near inlet section. Cooling performance seems stable again.

From: Guest | Date: 8/24/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Installation Experience

Wasnt completely sure this would match at first since the ice maker stopped filling correctly. Thankfully access was a little tight behind the panel and everything is working again.

From: Guest | Date: 9/3/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

After dealing with a situation where the water flow became inconsistent, we installed this replacement part. Repair solved the original problem. Repair turned out easier than expected honestly.

From: Guest | Date: 9/6/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Repair Outcome

Took around thirty minutes from start to finish while replacing the old component because the ice maker stopped filling correctly. Cooling performance seems stable again.

From: Peter | Date: 5/3/2026 9:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews