26" Wide X 14" High Parallel Blade Zone Damper with 24Vac, Power Closed/Spring Return Open, Two Position, Synchronous Motor mounted on 14" Side
Existing reviews
Repair Note
4
Access was a little tight behind the panel while replacing the old component because the original component had worn out over time. No leaks or issues noticed so far.
Guest|7/21/2025 9:36 AM
Was this review helpful?YesNo (0/0)
Repair Outcome
4
The appliance suddenly stopped working properly on our appliance ended up being caused by a failing part. Connector alignment matched better than expected and the replacement solved it.
Guest|1/9/2026 8:36 AM
Was this review helpful?YesNo (0/0)
Installation Experience
5
Used this replacement after the appliance suddenly stopped working properly. Mounting holes lined up correctly during install. Everything powered back on correctly afterward. Would probably order again if needed.
Guest|4/24/2026 9:36 AM
Was this review helpful?YesNo (0/0)
Installation Experience
5
Installed this when the original component had worn out over time. Connector alignment matched better than expected. Appliance has been running normally since then.
Guest|5/4/2026 9:36 AM
Was this review helpful?YesNo (0/0)
Only registered users can write reviews
26L X 14H Parallel 2pos24v S/R For Honeywell Part# ZD26X14TZ