VisionPro 8000 with RedLink, 18-30Vac or 750mV, 7 Day Programmable, Up to 1 Heat/1 Cool Heat Pump or up to 1 Heat/1 Cool Conventional when used Standalone, Up to 4 Heat/2 Cool Heat Pump or UP to 3 Heat/2 Cool Conventional when used with the Equipment Interface Module, Heat-Off-Cool-Auto-Emergency Heat System Switching, Auto-On-Circulating-Follow Schedule Fan Switching, Auto or Manual Changeover, 40-90 Degree Heat Temperature Setting Range, 50-99 Degree Cool Temperature Setting Range, Battery or Hardwired, Screw Terminals, 5-90% RH Non Condensing Operating Humidity Range, 10-60% Humidification Setting Range, 40-80% RH Dehumidification Range

Existing reviews

Helpful Product Insight

The original component had worn out over time on our appliance ended up being caused by a failing part. Took around thirty minutes from start to finish and the replacement solved it.

From: Guest | Date: 8/2/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Repair Outcome

After dealing with a situation where the older unit needed replacement part, we installed this replacement part. Appliance has been running normally since then. Packaging was decent and part arrived undamaged.

From: Guest | Date: 11/27/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Installation Experience

The appliance suddenly stopped working properly on our appliance ended up being caused by a failing part. Fitment on our appliance was accurate and the replacement solved it.

From: Guest | Date: 2/19/2026 8:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

Connector alignment matched better than expected while replacing the old component because the appliance suddenly stopped working properly. No leaks or issues noticed so far.

From: Guest | Date: 3/8/2026 9:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews