Immersion Temperature Sensor, Ni RTD, 1k Ohm @ 32F (LG-Ni) Output Signal, 0 Degree - 250 Degree Fahrenheit (-18 Degree - 121 Degree Celsius) Temperature, 6 inches (thermowell included) Probe Length, Connection Type: Leads, No Display,

Existing reviews

Repair Outcome

Had to replace this after our original component had worn out over time. Took around thirty minutes from start to finish. Repair solved the original problem. Would probably order again if needed.

From: Bob | Date: 8/7/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

Wasnt completely sure this would match at first since the original component had worn out over time. Thankfully connector alignment matched better than expected and everything is working again.

From: Peter | Date: 9/6/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

After dealing with a situation where the appliance suddenly stopped working properly, we installed this replacement part. Repair solved the original problem. Worth verifying model number before ordering though.

From: Guest | Date: 11/4/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Repair Outcome

Wasnt completely sure this would match at first since the original component had worn out over time. Thankfully installation wasnt too difficult overall and everything is working again.

From: Bob | Date: 12/12/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews