Immersion Temperature Sensor, 100k Ohm Thermistor Output Signal, 0 Degree - 250 Degree Fahrenheit (-18 Degree - 121 Degree Celsius) Temperature, 2.5 inches (thermowell included) Probe Length, Connection Type: Leads, No Display,

Existing reviews

Installation Experience

After dealing with a situation where the appliance suddenly stopped working properly, we installed this replacement part. Everything powered back on correctly afterward. Repair turned out easier than expected honestly.

From: Guest | Date: 7/7/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

Wasnt completely sure this would match at first since the older unit needed replacement part. Thankfully access was a little tight behind the panel and everything is working again.

From: Guest | Date: 9/24/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Compatibility Feedback

Installed this when the original component had worn out over time. Connector alignment matched better than expected. Everything powered back on correctly afterward. Worth verifying model number before ordering though.

From: Guest | Date: 10/22/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews