Immersion Temperature Sensor, 10k Ohm Type 2 Thermistor Output Signal, 0 Degree - 250 Degree Fahrenheit (-18 Degree - 121 Degree Celsius) Temperature, 4 inches (thermowell included) Probe Length, Connection Type: Leads, No Display,

Existing reviews

Repair Note

Wasnt completely sure this would match at first since the appliance suddenly stopped working properly. Thankfully installation wasnt too difficult overall and everything is working again.

From: Guest | Date: 9/8/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

The original component had worn out over time on our appliance ended up being caused by a failing part. Connector alignment matched better than expected and the replacement solved it.

From: Guest | Date: 12/14/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Replacement Observation

Connector alignment matched better than expected while replacing the old component because the older unit needed replacement part. Everything powered back on correctly afterward.

From: Guest | Date: 1/19/2026 8:36 AM

Was this review helpful? Yes No (0/0)

Installation Experience

Took around thirty minutes from start to finish while replacing the old component because the older unit needed replacement part. Repair solved the original problem.

From: Guest | Date: 2/12/2026 8:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews