Immersion Temperature Sensor, 4-20mA Output Signal, 30 Degree - 250 Degree Fahrenheit (-1 Degree - 121 Degree Celsius) Temperature, 4 inches (thermowell included) Probe Length, Connection Type: Leads, No Display,

Existing reviews

Repair Note

Took around thirty minutes from start to finish while replacing the old component because the appliance suddenly stopped working properly. Noise issue disappeared after replacement.

From: Bob | Date: 7/19/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Compatibility Feedback

Fitment on our appliance was accurate while replacing the old component because the appliance suddenly stopped working properly. Appliance has been running normally since then.

From: Guest | Date: 10/6/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Installation Experience

Installation wasnt too difficult overall while replacing the old component because the older unit needed replacement part. Everything powered back on correctly afterward.

From: Bob | Date: 2/2/2026 8:36 AM

Was this review helpful? Yes No (0/0)

Helpful Product Insight

After dealing with a situation where the original component had worn out over time, we installed this replacement part. Everything powered back on correctly afterward. Would probably order again if needed.

From: Guest | Date: 5/2/2026 9:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews