4.4 Gallon Tank Volume, 100 PSI Max Working Pressure, 240F Max Operating Temperature, Non-ASME Construction, Hydronic Heating Diaphragm Expansion Tank Factory Precharged to 12 PSI (Model HFT-30)

Existing reviews

Repair Outcome

Wasnt completely sure this would match at first since the original component had worn out over time. Thankfully needed basic hand tools only and everything is working again.

From: Guest | Date: 8/28/2025 9:36 AM

Was this review helpful? Yes No (0/0)

Repair Outcome

Had to replace this after our older unit needed replacement part. Installation wasnt too difficult overall. Unit completed a full cycle without issues. Repair turned out easier than expected honestly.

From: Guest | Date: 11/19/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Repair Note

Picked this up cause the appliance suddenly stopped working properly. Had to double check model compatibility first. Everything powered back on correctly afterward. Part quality feels reasonable compared to original one.

From: Bob | Date: 12/11/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Installation Experience

Had to double check model compatibility first while replacing the old component because the original component had worn out over time. Noise issue disappeared after replacement.

From: Guest | Date: 12/24/2025 8:36 AM

Was this review helpful? Yes No (0/0)

Only registered users can write reviews